-> All of this will be done on the Second-PC unless specifically instructed otherwise.
1)Make sure the DMA is properly inserted in a PCIe slot on the Gaming-PC.
2) Make sure that the Gaming-PC is powered on.
3) Plug the DMA USB-Cable into the "Update" port or "JTAG" on the DMA Card and the other end into the 2nd-PC. (Cloest to Mobo)
Download DMA Flash Files:
4) Go into the CH341PAR FOLDER, then into the CH341PAR FOLDER again
5) Run “SETUP” and then click INSTALL as shown below in the screenshot
6) Once “Driver Installed Successfully” pops up, you may move forward to the next step
6.1) Confirm that you see USB Highspeed-JTAG/12C…CH347T in Device Manager>Interface
7. Go into the ch347-main folder then into the CH347FPGATool folder run program as admin.
8) Change the highlighted section on top to match
9) Use FW Selector to find the path to your FW.bin
10) After selecting FW, hit "Flash".
10.1) Once finished it will show "Info: Close the CH347"
11. Then do a full reboot on the main and 2nd pc(shut down, wait 30 seconds, switch over to the data port & then power the pc’s back on)
11.If you still see FT601 on your 2nd pc while in the data port and the speedtest runs successfully, you can skip step 12.
11. After powering back on, redownload the onto the 2nd pc, and make sure it shows at FT601 in device manager on the second pc.
12. Now download “” and run the “1.” full speed test.
