-> All of this will be done on the Second-PC unless specifically instructed otherwise.
1. Make sure the DMA is properly inserted in a PCIe slot on the Gaming-PC.
2. Make sure that the Gaming-PC is powered on.
3. Plug the DMA USB-Cable into the "Update" port or "JTAG" on the DMA Card and the other end into the 2nd-PC.
Download DMA Flash Files:
DMA-Flash-Files
4. Go into the CH341PAR FOLDER, then into the CH341PAR FOLDER again
5. Run “SETUP” and then click INSTALL as shown below in the screenshot
6. Once “Driver Installed Successfully” pops up, you may move forward to the next step
7. Go into the ch347-main folder then into the CH347FPGATool folder
(RENAME THE FIRMWARE .BIN FILE INTO “firmware”)
8. Select Firmware File that you renamed to “firmware” and Click FLASH.
9. It will then start going through sectors, Once the sectors are complete, wait a minute and then something along the lines of; “Close the ch347/Update Complete.” You may close the CH347FPGHATOOL.
10. Then do a full reboot on the main and 2nd pc(shut down, wait 30 seconds, switch over to the data port & then power the pc’s back on)
11.If you still see FT601 on your 2nd pc while in the data port and the speedtest runs successfully, you can skip step 12.
11. After powering back on, redownload the
FTD3X driver onto the 2nd pc, and make sure it shows at FT601 in device manager on the second pc.
If the DMA test is successful it means the DMA is working and you’re good to go!
REMEMBER SOMETIMES FW CAN CAUSE CHANGES IN YOUR DMA CARDS SPEEDS
