Hardware Setup (Game PC)

Setting up DMA card on gaming PC

1. Power off your main PC.

2. Plug the board into your main PC. (Any PCI-e slot)

1. Connect your DMA Card via the Data Port to your Radar PC (2nd PC), using the provided USB Cable (and any USB adapters necessary for different USB Types).

2. Power on your main PC and enter the BIOS settings.

3. Disable/Adjust the following Settings on Game PC System BIOS:

We primarily need to disable Virtualization on your system, since this can interfere with DMA Memory Reading. Disable any Virtualization settings in your System BIOS.

• On Intel CPU Motherboards this will usually be listed as:

- Virtualization / IOMMU

- VT-d

On AMD CPU Motherboards this will usually be listed as:

- Virtualization / IOMMU

- SVM

• Disable NX-Bit (Only if available. If you can’t find it skip this step)

• If needed set PCI Slot of DMA Card from Auto to Gen1 (Advanced > PCI Settings)

1. Make sure Memory Integrity / Core Isolation is Off on your Game PC. This may be unavailable/already disabled on some systems, so if you cannot get this page to load, you are likely already good to go. See Device protection in Windows Security - Microsoft Support