ISOLATE 35T FLASHING GUIDE

1. Plug the USB cable into the JTAG port on the DMA card.

2. Download the JTAG driver to your secondary PC's desktop.

3. Install the JTAG driver.

• 

1. Download and open the Flashing Tool, click the blank button, and select your firmware file.Make sure your firmware .bin is named “pcileech_squirrel_top.bin”

• 

1. Press Start to begin the flashing process. It should take about 1 minute to complete. After pressing start you will see it start going through sectors, up until 23/24 sectors.Once the sectors complete give it a little bit until it says “Update Complete” or “Close CH347” (BE PATIENT IT CAN TAKE SOME TIME)

• 
• 6. Once you see the "Update Complete" prompt, the flashing process was successful, and the DMA device will need to do a full reboot.

• 7. Do a full reboot on the main and 2nd pc(shut down, wait 30 seconds, switch over to the data port & then power the pc’s back on)

• 8. After powering back on, redownload the FTD3X driver onto the 2nd pc, and make sure it shows at FT601 in device manager on the second pc.
• 9. Now download “lone’s dma tools” and run the “1.” full speed test.

• DMA SPEED TEST TOOL: Download

If the DMA test is successful it means the DMA is working and you’re good to go!

REMEMBER SOMETIMES FW CAN CAUSE CHANGES IN YOUR DMA CARDS SPEEDS